Lista przedmiotów z materiałami udostępnionymi dla studentów

Dla_studentów
  • Increase font size
  • Default font size
  • Decrease font size

Jakub Winer

Rozproszone sterowanie ogrzewaniem


Distributed controller of heating system


Opiekun pracy dyplomowej: dr inż. Marcin Kociołek
Praca dyplomowa inżynierska obroniona 2013-02-18
Streszczenie pracy dyplomowej:
Domy jednorodzinne do ogrzewania najczęściej wykorzystują systemy centralnego ogrzewania. Celem niniejszej pracy było zaprojektowanie systemu sterującego ogrzewaniem w domach jednorodzinnych. System ma na celu sterować temperaturą w pokojach oraz mocą wydzielaną przez kocioł grzewczy. Cel pracy został osiągnięty. Zaprojektowano system oparty na rozwiązaniu zdecentralizowanym z magistralą. Projekt rozpoczęto od stworzenia schematów ideowych sieci i sterowników. Kolejnym etapem był dobór odpowiednich elementów . Po dobraniu elementów, zostały stworzone schematy sterowników i układów mocy. Następnym etapem było zaprojektowanie płytek PCB. Płytki zostały wykonane i zmontowane. Ostatnim etapem było uruchomienie i testowanie systemu. Praca składa się z 6 numerowanych rozdziałów. W rozdziale pierwszym zawarto wstęp. W drugim rozdziale omówiono systemy centralnego ogrzewania i sposoby ich sterowania. W rozdziale trzecim przedstawiono projekt budowanego systemu. W rozdziale czwartym opisano programy mikrokontrolerów wbudowane w poszczególne moduły systemu. W rozdziale piątym opisano uruchomienie i test systemu. W rozdziale szóstym opisano podsumowanie.
Abstract:
The most popular heating in single-family houses consist of furnace and heaters in form of convectors or radiators connected by hydraulic pipes. The goal of this thesis was to design control units for such system. The goal was achieved. The designed control system consist of distributed controllers connected by the designated bus. The following tasks were accomplished during preparation of the thesis: design of architecture of the system, design, assembly and first start of furnace and heaters controllers, creation of control programs for distributed controllers and tests of the system. The thesis consist of 6 numbered chapters. The first chapter is the introduction. The second chapter discusses different systems of central heating and methods of their controls. The third chapter presents the design of the furnace and heaters controllers. The fourth chapter describes programs written for microcontrollers used in designed controllers. The fifth chapter presents the first start and tests of designed controllers. The sixth chapter is the summary.