Lista przedmiotów z materiałami udostępnionymi dla studentów

Dla_studentów
  • Increase font size
  • Default font size
  • Decrease font size

Kamil Cłapa

Sterownik pieca CO


Controller of central heating furnace


Opiekun pracy dyplomowej: dr inż. Marcin Kociołek
Praca dyplomowa inżynierska obroniona 2014-10-10
Streszczenie pracy dyplomowej:
Kotły na paliwa stałe, takie jak: węgiel, miał, ekogroszek, pellet, stanowią popularne źródła ciepła w systemach centralnego ogrzewania gospodarstw domowych. Zastosowanie mikroprocesorowego sterownika kontrolującego pracę kotła polepsza jego parametry pracy oraz wpływa na energooszczędność. Celem niniejszej pracy było zaprojektowanie, zmontowanie, uruchomienie i przetestowanie prototypu sterownika kotła centralnego ogrzewania na paliwo stałe. Cel został zrealizowany. W ramach niniejszej pracy zaprojektowano, wykonano i uruchomiono prototyp sterownika kotła centralnego ogrzewania. Prototyp wykonano wykorzystując istniejącą płytkę uruchomieniową z mikrokontrolerem Atmega 2560. Do płyty prototypowej dołączono gotowy moduł interfejsu Ethernet oraz cztery moduły zaprojektowane i wykonane przez dyplomanta (panel sterownia z klawiaturą, układ mocy, interfejs karty pamięci SD, układ RTC). Dla prototypu przygotowano pierwszą wersję oprogramowania sterującego pracą kotła. Działanie urządzenia zweryfikowano za pomocą prostego testu.
Abstract:
Furnaces for solid fuels, such as coal, coal dust, eco-pea coal, pellets are a common sources of heat for home central heating systems. The use of microprocessor controller to control the furnace improves its operating parameters and has influence on its efficiency. The aim of this work was to design, assembly, run and test the prototype of the controlling unit for solid fuel central heating furnace. The goal has been achieved. As part of this work a prototype of the central heating furnace controller was designed, manufactured and runned. The prototype was made using the prototype board with ATmega 2560 microcontroller. The prototype board included Ethernet interface module and four modules (control panel with keyboard, power device, SD memory card, RTC) designed and built by graduate student. For the prototype was prepared the first version of the software that controls the boiler. Operation of the device was verified by a simple test.