Lista przedmiotów z materiałami udostępnionymi dla studentów

Dla_studentów
  • Increase font size
  • Default font size
  • Decrease font size

Filip Jóźwiak

Semi-automatic fault detection system for panelized printed board circuits


Półautomatyczny system diagnostyczny dla paneli z obwodami drukowanymi


Opiekun pracy dyplomowej: dr inż. Piotr Korbel prof. ucz.
Praca dyplomowa BSc - IFE obroniona 2018-02-14
Streszczenie pracy dyplomowej:
Zaprezentowana praca inżynierska skupia się na zaprojektowaniu półautomatycznego systemu diagnostycznego dla paneli z obwodami drukowanymi. System ten składa się z układu zasilającego i raportującego. Celem pierwszego z jest dostarczenie zasilania i dostosowanie napięcia wejściowego. Celem drugiego jest pobieranie danych podczas testu i zapisywanie ich w formie raportu. W pierwszej części pracy widnieje opis problemu i pogląd celu i zakres pracy. By to opisano hardware i software użyty w projekcie, zarówno jak stan obecnej technologii w dziedzinie systemów diagnostycznych dla PCB. W następnej częsci pracy opisany jest proces projektu. Pierwsza część projektu polegała na wyborze odpowiedniego żródła zasilania jak i portu. Zaprojektowany układ zasilający został później przetestowany za pomocą symulacji zrobionych w programie LTSpice. Po zweryfikowaniu funkcjonalności układu zasilającego nastąpił projekt PCB. Projekt ten składał się z układu zasilającego i owiertu pod igły testowe. W ostatniej części pracy opisany został prototyp systemu raportującego. Prototyp ten nie jest zaprojektowany aby być wprowadzonym do gotowego produktu, ale do przetestowania idei raportowania. Słowa kluczowe: system diagnostyczny, panel obwodów drukowanych, projekt PCB, układ wbudowany, tester funkcjonalności obwodu elektronicznego
Abstract:
The presented thesis focuses on design of the semi-automatic fault detection system for panelized printed circuit board. The system consists of two main units. Namely, power supply circuit and reporting system. The goal of the former was to supply power to the circuit and properly manipulate voltage. The aim of the latter was to read data from the test and store it in form of a report. In the first part of the thesis I decided to describe the problem I am facing and provide overview of the aim and scope of the project. To achieve this task software and hardware used in the project was described, as well as state of art was investigated. Later on the process of design is described. First part of design is dedicated to port choice which strictly influences the measures taken to design a power supply circuit. Having designed the power supply circuit, its functionality is confirmed by means of LTSpice simulations. After validating the aforementioned design a PCB, comprising both power circuit and appropriate drill for testing needles, had to be designed. The last part of the thesis describes the process of reporting system development or actually a prototype of reporting system. The prototype is not ready to be introduced into the real device, but it shows principles of its operation quite precisely. Keywords: fault detection, panelized printed circuit boards, PCB design, circuitry functionality testers, embedded system