Lista przedmiotów z materiałami udostępnionymi dla studentów

Dla_studentów
  • Increase font size
  • Default font size
  • Decrease font size

Mateusz Florczak

Elektroniczne systemy do pomiaru parametrów powietrza


Electronic systems for air quality measurement


Opiekun pracy dyplomowej: dr inż. Robert Olbrycht
Dodatkowy opiekun pracy dyplomowej: dr inż. Mariusz Felczak

Praca dyplomowa inżynierska obroniona 2019-01-24
Streszczenie pracy dyplomowej:
Celem pracy było wykonanie stacji do badania stanu zanieczyszczenia powietrza. Mierzonymi wartościami były gazy TVOC i CO2 mierzone czujnikiem CCS811 oraz pyły PM2,5 i PM10 mierzone czujnikiem SDS011, które były porównywane z innymi dostępnymi na rynku czujnikami. Dobrano elementy niezbędne do wykonania stanowiska. Odczyt dokonywano z wyświetlacza oraz zapis danych na kartę SD. Wykonano płytkę PCB w programie Altium Designer. Układ płytki zaplanowano tak, aby długość ścieżek między elementami była możliwie najkrótsza. Płytka PCB była również miejscem przymocowania czujnika SDS011. Zaprojektowano obudowę do stacji pomiarowej, a następnie wydrukowano na drukarce 3D. Zaplanowano wszystkie niezbędne otwory w obudowie, takie jak wyjście na zasilanie, obecność czujnika CCS811 poza obudową oraz otwór na dojście powietrza i kratownicę przy wentylatorze dla czujnika SDS011. Zaprogramowano układ tak, by między wszystkimi użytymi elementami odbyła się komunikacja za pomocą mikrokontrolera. Wykonano pomiary sprawdzające pracę czujników w różnych warunkach wewnętrznych, analizując wiarygodność pomiarową. Słowa kluczowe: Zanieczyszczenie powietrza, CO2, TVOC, CCS811, PM2,5, PM10, SDS811, Stacja pomiarowa.
Abstract:
The purpose of the work was to construct a station for testing the state of air pollution. The measured values were gases TVOC and CO2 by CCS811 sensor and dusts PM2,5 and PM10 measured by SDS011 sensor which were compared with other sensors available on the market. Well-matched elements necessary to perform the measuring station. The readout was made from the LCD display and the data was saved to the SD card. A PCB board was made in the Altium Designer program. The layout of the tiles was planned in such a way that the length of wires between the elements was as short as possible. The PCB was also the place to mount the SDS011 sensor. The housing for the measuring station was designed and then printed on a 3D printer. All the necessary openings in the housing were planned, such as the power output, the presence of the CCS811 outside the housing, a hole for air inlet and truss at the ventilator for the SDS011. The system was programmed that the communication with the microcontroller took place between all used elements. Measurements were made to check the work of sensors in various inside conditions, analyzing the measurement reliability. Keywords: Air pollution, CO2, TVOC, CCS811, PM2,5, PM10, SDS011, measuring station.