Lista przedmiotów z materiałami udostępnionymi dla studentów

Dla_studentów
  • Increase font size
  • Default font size
  • Decrease font size

Wiktoria Jachółkowska

Otrzymywanie spienionego polilaktydu metodą separacji faz z wykorzystaniem sublimatora


Obtaining foamed polylactide by the phase separation method with the use of a sublimator


Opiekun pracy dyplomowej: dr hab. inż. Anna Sobczyk-Guzenda
Dodatkowy opiekun pracy dyplomowej: mgr inż. Małgorzata Suwalska

Praca dyplomowa inżynierska obroniona 2023-02-06
Streszczenie pracy dyplomowej:
Celem pracy było opracowanie metody otrzymywania porowatego poli-L-laktydu metodą termicznie indukowanej separacji faz oraz zbadanie morfologii i właściwości fizykochemicznych otrzymanych struktur. Podczas wytwarzania próbek dobierany był: rodzaj zastosowanego rozpuszczalnika, stężenie polimeru w rozpuszczalniku, czas i temperatura sublimacji oraz wpływ i stężenie poroforu. Do analizy właściwości fizykochemicznych otrzymanych skafoldów wykorzystano: skaningową mikroskopię elektronowa, analizę różnicowej kolorymetrii skaningowej, badanie kąta zwilżania wodą, ocenę porowatości i badanie lepkości roztworów, z których powstały rusztowania kostne. Otrzymane skafoldy posiadały zróżnicowaną mikrostrukturę w zależności od użytego rozpuszczalnika. Z badań lepkości wynika, że im większa lepkość roztworów tym mniejsza porowatość. W zależności od przygotowania skafoldów, ich powierzchnia wykazuje charakter hydrofobowy lub hydrofilowy, a ich właściwości termiczne nie ulegały istotnym zmianom. Słowa kluczowe: Poli-L-laktyd, metoda termicznie indukowanej separacji faz, inżynieria tkankowa, rusztowania kostne, spienianie matrycy polimerowej
Abstract:
The aim of this study was to development of a method of obtaining porous poly-L-lactide by the thermally induced phase separation and to evaluate the morphology of surface and physicochemical properties of scaffolds. During the preparation of the samples, the following were selected: the type of solvent used, the concentration of the polymer in the solvent, sublimation time and temperature, the effect and concentration of the blowing agent. The following techniques were used: scanning electron microscopy, differential scanning calorimetry, contact angle survey, porosity evaluation, viscosity of the solutions from which the scaffolds were formed. The obtained scaffolds had a differentiated microstructure depending on the solvent used. Viscosity of solutions shows that the higher viscosity of solutions the smaller porosity. Depending on the preparation of the scaffolds, their surface shows both hydrophobic and hydrophilic character, and their thermal properties did not change meaningly. Keywords: poly-L-lactide, methods of thermally induced separation phase, tissue engineering, scaffolds, foaming of polymer matrix.